Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST NOTICE Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the 4 - 48 NOTICE Check each pulley for damage, wear of the V-groove, an d wear of the V-belt. In particular, be sure to c heck that the V-belt is not touching th e bottom of the V-groov e. ask the Komatsu distributor in your territory to replace the belts with new ones. g little allowance for adjustment. t. rd coming from the belt. t it after one hour of operation.

In case any of the following occurs, ask the Komatsu d istributor in y our territory to replace the belt • The fan b • A cut or • Slipping elt has elongated, leavin g little allowance f or adjustment crack is found on the bel or creaking sound is hea rd coming from th When the n ew V-belt is set, readjus t it after one hour o (Machine eq uipped with cab) (If eq CHECKING d deflection between the air conditioner compress The standar pulley and cr ank pulley when pres sed with a thumb (approx. 98 (10 kg)) shou ld be approx. 16 to 2 0 mm (0.6 to 0.8 in). When a belt tension gauge is use d, the standard te nsion is with a range of 35 3 to 530 N (36 to 54 kg).

CHECK WHEN CHANGING THE V-BEL The standard deflection between t he air conditione r compresso r pulley and fan pulley when pressed with a thumb (approx. 98 N (10 kg)) should be a pprox. 12 to 17 mm (0.5 to 0 .7 in). When a belt tension gauge is use d, the standard te nsion is with in a range of 530 to 745 N ( REMARK When the be lt has been replaced with a new part, a high tensio n is necessary, so the initial tension is in the value given above. ADJUSTING 1. Loosen n 2. Tighten n uts (1) and (2), and m ove compressor (3) to adjus uts (1) and (2) to hol d compressor (3) in position.

In case any territory to • The fan b • A cut or • Slipping of the following occurs, ask the Komatsu distributor in yo replace the belts with new ones. elt has elongated, leaving little allowance for adjustment crack is found on the bel t. rd coming from the belt. t it after one hour of operation. or creaking sound is hea rd coming from th When the n ew V-belt is set, readjus t it after one hour o