Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE HYDRAULIC TANK, ADD OIL details, see "CHECK OIL LEVEL IN 4 - 61 8. Remove mounting bolts (6) of filter cover (5) at the top of the e force of spring (7) may make he cover pushed down when valve (8), then remove element material inside the tank, then et bypass valve (8), spring (7), aged or deteriorated, replace it. lts, push down the cover and oil through oil filler port (F), then t the specified level. For details, HYDRAULIC TANK, ADD OIL tank, then remove the cover. When the cover is removed, th the cover fly off, so keep t removing the bolts. 9. Remove spring (7) and bypass (9). Check that there is no foreign clean it.

Install new element (9), then s 10. 11. and cover (5) to the tank. If the O-ring of the cover is dam 12. When installing the cover bo tighten the bolts evenly. 13. Add the refill amount of engine 14. install the cap. Check that the hydraulic oil is a see "CHECK OIL LEVEL IN (PAGE 4-43)". 15. Run the engine at low idle, an d extend and retract the steering, bucket, and lift arm cy linders 4 to 5 times. Be careful not to operate the cylind er to the end of its stroke (stop approx. 100 mm (3.9 in) b efore the end of s troke).

NOTICE If the engine is run at high speed imme diately after startup or a cylinder is pushed up to its stroke end, a ir taken inside the c ylinder may cause damage to the piston packi ng. 16. Next, operate the steering, buc end of their stroke 3 to 4 times, bleed plug (10) to bleed the ai bleeding the air, tighten plug ( Run the engine at low idle whe 17. Check that the hydraulic oil is a see "CHECK OIL LEVEL IN (PAGE 4-43)". 18. Next, increase the engine spe ed and repeat the procedure in Step 16 to bleed the air. Continue this operation until no more air comes out fro m plug (10). operation, tighten plug (10). Nm (1.15 ± 0.15 kgm, 8.3 ± 1.1 lbft) 19.

After completing the air bleed Tightening torque: 11.3 ± 1.5 20. Check that the hydraulic oil le vel and add oil to the specified level. For (PAGE 4-43)". of oil from the filter cover mount. l. For HYDRAULIC TANK, ADD OIL 21. Check that there is no leakage