. MAINTENANCE SERVICE PROCEDURE CHECKING FUNCTION OF ACCUMULATOR For details of handling the accumulator, see Section "ACCUMULATOR (PAGE 2-35)". your Komatsu distributor for inspection or CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, request your Komatsu distributor for service. CHECK INJECTOR See Section "A REGULATION AREA (PAGE 4-16)". 4 - 66 PPC ACCUMULATOR If the engine stops with the work equipment raised, and it is impossibl e to start the engine again, it is possible as an emergency measure to actuate the valve with the oil pressure stored in the accumulator and lower the work equipment to the ground. 1. Apply the parking brake.
2. Raise the work equipment to the maximum height, then operate the lift arm control lever to HOLD position (b). 3. Stop the engine. 4. Leave the work equipment lock lever in the FREE position. 5. Check that the area around the machine is safe, then operate the lift arm control lever to FLOAT position (d) and lower the work equipment to a point 1m above the ground. 6. When the lift arm comes to the 1m position, return the lift arm control lever to LOWER position (c), and lower the work equipment slowly to the ground. REMARK Carry out the check within 2 minutes after stopping the engine.
If the machine is left with the engine stopped, the accumulator pressure will drop and it will be impossible to check the cause of the problem. red in the accumulator and lower the work If the work equipment stops while it is moving, the gas pressure in th Please contact your Komatsu distributor to have the accumulator ins Replace the accumulator every 4000 hours or every 2 years. CHECK ALTERNATOR, STARTING MOTOR The brush may be worn or have no grease on the bearing, so conta repair.
If the engine is started frequently, carry out inspection every 1000 ho CLEAN AND CHECK TURBOCHARGER If there is carbon or oil sludge stuck to the blower impeller, it will lower the performance of the turbocharger or cause it to break, so ask your Komatsu distributor to carry out the cleaning. CHECK VIBRATION DAMPER Check that there are no cracks or peeling in the outside surface of th If any cracks or peeling are found, contact your Komatsu distributor t