Komatsu — EVERY 4000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE INJECTOR ASSEMBLY See Section "A REGULATION AREA (PAGE 4-16)". CHECKING FOR LOOSENESS OF HIGH-PRESSURE CLAMP, HARDENING OF RUBBER 4 - 68 CHECK WATER PUMP Check th at there i s n o play in the pulley or any grease l eakage, water leakage, or clogging of the drain hole. If any problem i s found, contact your Komatsu distributor for disassembly and repair or CHECK AIR CONDITIONER COMPRESSOR, ADJ (Machine equipped with cab) (If equipped) As speci al tool is required for checking and adjusting th e parts, request Komatsu distributor for s ervice.

CHECK INJECTO See Section "B See Section "A Check vi sually and t ouch with your fingers to check th at there are no loose bolts or hardening of rubber par ts at clamps (1 ) to (10) . If there is any looseness or hardene d rubber, contact your Komatsu distributo r for replacement.