Komatsu — HANDLING LOAD METER DISPLAY

. ATTACHMENTS, OPTIONS HANDLING LOAD METER CARRYING OUT CALIBRATION (ADJUSTING 0 POINT) WHEN EMPTY panel selector switch 1 and display panel selector switch 1, then press panel mode selector switch 2 and 6 - 15 REMARK out calibration with the machine unloaded, the accuracy is improved by doing as follows. When carrying out calibration with the machine unload ed, the accuracy is i mprove d by doing Hydraulic o il temperature: Carry out the calibration with the hydraulic o il temperature in the normal op erating range (appr ox. 60 to 85°C (140 to 185°F), near the center of the white range on the hydraulic oil temperature 85°C erature gauge).

(Compensa te for the e rror caused by the temperatur e of the pressure sensor. T his makes i t possible to c arry out calibration t hat matches th the engine speed constant at the speed used for norma hows the maximum effect. When carrying out the actual urate measurement can be made.) t at full tilt. Engine spe ed: When operations (near the r ated (The effect of compensati measureme nt, even i f the engine speed varies, acc urate measurement can be Bucket pos ture: Carry out calibration with the bucke Carry out th e measuremen t for the weight also at the full tilt.

If the bucket i s not a t full tilt, the position of the center of gravity of the load changes and the load cannot b e measured accurately. Work equip ment speed: W hen carrying out calibrati on, operate the wor seconds to raise from the travel posture to the maxi mum height of the lif t arm.) (This is don e in order to in crease the measurement data when carrying out cal 1. Check that the norm al service meter and time are di the charac ter display 2. Press the (‘) of monitor "LOAD ME TER". 3. Press the (‘) of monitor the (>) or ( select "CA LIBRATION".