Operation to allow operation in shallow water. EWM00660 WARNING G Place the gear shift in neutral before setting up for shallow water cruising. G Return the outboard motor to its normal position as soon as the boat is back in deeper water. ZMU03453 ECM00260 CAUTION: 3. Push the power trim and tilt switch / pow- er tilt switch “ ” (down) to lower the out- board motor to the desired position. Do not tilt the outboard motor up so that the cooling water inlet on the lower unit is above the surface of the water when set- ting up for and cruising in shallow water. Otherwise severe damage from overheat- ing can result. UP DN DN EMU28185 Procedure for power trim and tilt / power tilt models 1.
Place the remote control lever / gear shift lever in neutral. ZMU01936 DN ZMU03524 2. Slightly tilt the outboard motor up to the desired position using the power trim and tilt switch / power tilt switch. Cruising in shallow water The outboard motor can be tilted up partially to allow operation in shallow water. EMU28060 EMU28090 Power trim and tilt models / power tilt models The outboard motor can be tilted up partially 38