Yamaha Motor Corporation, USA 150TR — Checking Fuel System

Maintenance ple, if the center electrode porcelain is very white, this could indicate an intake air leak or carburetion problem in that cylinder. Do not attempt to diagnose any problems yourself. Instead, take the outboard motor to a Yamaha dealer. You should periodically re- move and inspect the spark plug because heat and deposits will cause the spark plug to slowly break down and erode. If electrode erosion becomes excessive, or if carbon and other deposits are excessive, you should re- place the spark plug with another of the cor- rect type. spark plug to the correct torque. Spark plug torque: 25.0 Nm (18.4 ft-lb) (2.55 kgf-m) NOTE:

If a torque-wrench is not available when you are fitting a spark plug, a good estimate of the correct torque is 1/4 to 1/2 a turn past fin- ger-tight. Have the spark plug adjusted to the correct torque as soon as possible with a torque-wrench. EMU28962 Checking fuel system Standard spark plug: BR7HS-10 EWM00060 Gasoline and its vapors are highly flam- mable and explosive. Keep away from sparks, cigarettes, flames, or other sources of ignition. WARNING Before fitting the spark plug, measure the electrode gap with a wire thickness gauge; adjust the gap to specification if necessary. EWM00910 WARNING Leaking fuel can result in fire or explo- sion. G Check for fuel leakage regularly.

G If any fuel leakage is found, the fuel system must be repaired by a qualified mechanic. Improper repairs can make the outboard unsafe to operate. 1. Spark plug gap 2. Spark plug I.D. mark (NGK) 3. Spark plug part number Check the fuel lines for leaks, crack, or mal- function. If a problem is found, your Yamaha dealer or other qualified mechanic should re- pair it immediately. Spark plug gap: 0.9–1.0 mm (0.035–0.039 in) When fitting the plug, always clean the gas- ket surface and use a new gasket. Wipe off any dirt from the threads and screw in the 49