Maintenance when installing the battery and discon- nect the black battery cable first when removing it. Otherwise, the electrical parts can be damaged. G The electrical contacts of the battery and cables must be clean and properly connected, or the battery will not start the engine. Connect the RED cable to the POSITIVE (+) terminal first. Then connect the BLACK ca- ble to the NEGATIVE (-) terminal. Using a single battery Connect both red cables to the (+) terminal. 2. Always keep the battery in a good state of charge. Installing a voltmeter will help you monitor your battery.
If you will not use the boat for a month or more, re- move the battery from the boat and store it in a cool, dark place. Completely re- charge the battery before using it. 3. If the battery will be stored for longer than a month, check the specific gravity of the fluid at least once a month and re- charge the battery when it is low. NOTE: Consult a Yamaha dealer when charging or re-charging batteries. EWM00590 WARNING Do not leave cable unconnected. If it acci- dentally contacts the NEGATIVE (-) termi- nal of the battery, there will be a short circuit. Electric system damage and a fire could result.
EMU29341 Connecting the battery EWM00570 WARNING Mount the battery holder securely in a dry, well-ventilated, vibration-free loca- tion in the boat. Install a fully charged bat- tery in the holder. 1. Red cable 2. Black cable 3. Battery ECM01121 CAUTION: G Make sure the main switch (on applica- ble models) is “ ” (off) before work- ing on the battery. Using an accessory battery Use a connecting cable between the (-) ter- minals of the starting battery and accessory battery. See the illustrations of the wiring connections. This cable must be made from G Reversal of the battery cables will dam- age the electrical parts. G Connect the red battery cable first 57