Trouble Recovery or stopping. ECM00380 Follow this procedure only in an emer- gency and just long enough to return to port for repairs. ZMU03466 1 7. Give a strong pull straight out to crank and start the engine. Repeat if neces- sary. EMU29670 Engine fails to operate 2 EMU29691 Ignition system malfunction If the battery voltage is low or in the unlikely event of an ignition system malfunction, the engine speed may become erratic or the en- gine may stop. In such a situation, follow the procedure below. 1. Remove the CDI unit cover or electrical cover, if equipped. ZMU03924 1. CDI unit 2.
Yellow cord EMU29741 Low oil level warning activates If the oil level is allowed to drop too low, the red segment will appear on the oil level indi- cator, the buzzer will sound, and engine speed will be limited to about 2000 r/min. If this happens, a reserve amount of oil can be pumped from the remote oil tank to the en- gine oil tank using the emergency switch. EWM01050 WARNING Be sure to stop the engine before per- forming this procedure. ZMU03923 2. Disconnect the yellow cord (emergency circuit) of the CDI unit to return to port. ECM00900 G If the emergency switch is held up too long, too much oil will be pumped into the engine oil tank, overflowing it.
Re- lease the switch when oil reaches the upper level line on the engine oil tank. EWM00350 WARNING When the yellow cord is disconnected, the idle and low speeds are slightly high- er than normal. Use care when starting off G Do not use this emergency procedure 65 CAUTION: CAUTION: