Wheels and Tires 40 40–01 Wheel Nut and Rim Nut Torque Check Insufficient wheel nut (rim nut) torque can cause wheel shimmy, resulting in wheel damage, stud breakage, and extreme tire tread wear. Excessive wheel nut torque can break studs and clamps (if so equipped), damage threads, and crack discs in the stud hole area. Use the recommended torque values, and follow the tightening sequence shown in Fig. 1 . After an 8- or 10-stud wheel has been installed, the wheel or rim nut torque must be rechecked after 50 to 100 miles (80 to 161 km) of operation. See Table 1 for wheel nut torque specifications, and see Fig. 1 for the wheel nut tightening sequence.
When checking wheel nuts on a dual disc assembly, remove one outer nut at a time, tighten the inner nut, then reinstall the outer nut. Repeat this procedure for all wheel nuts, using the tightening sequence shown in Fig 1 . After a 12-stud wheel rim has been installed, the wheel or rim nut torque must be rechecked as fol- lows: after the first load; every four hours of operation for a minimum of five days; When checking wheel or rim nut torque on 12-stud wheel rims, use the tightening sequence shown in Fig. 1 for each of the three stages of tightening as follows: every 8 to 10 hours of operation. 1. Tighten each nut 50 lbf·ft (68 N·m). 2. Tighten each nut 100 lbf·ft (136 N·m). 3.
Tighten each nut 150 lbf·ft (203 N·m). Western Star Maintenance Manual, September 2015 40/1 CAUTION