Daimler Trucks North America LLC Western Star — Western Star

Wheels and Tires 40 Wheel Fastener Torque Application Nut Size Wheel Manufacturer Torque (dry threads): lbf·ft (N·m) Rear Wheel Nut 3/4–10 OTR 50 (68) 100 (136) 150 (203) Spoke Wheel Rim Nuts Front Wheel Nut, 5- and 6-Spoke 3/4–10 Gunite 200–225 (271–305) Rear Wheel Nut, 5- and 6-Spoke With Non-Corrugated Channel Spacer 3/4–10 Gunite 200–225 (271–305) Rear Wheel Nut, 5- and 6-Spoke With Corrugated Channel Spacer 3/4–10 Gunite 240–260 (325–350) * Torque values given for these fasteners are for lubricated threads. Use the tightening sequence shown in Fig. 1 for each of the three stages of tightening.

On front axles with over 12,000 lb (5448 kg) capacity, tighten the wheel nuts 240 to 265 lbf·ft (325 to 359 N·m). Gunite part number W–854 nut with a phosphate-and-oil coating must be used. Table 1, Wheel Fastener Torque For additional information on 12-stud wheel rims, see Section 40.00, Subject 220 of the Western Star Workshop Manual. 40–02 Tire Check Tires should be inspected closely during the first 3000 to 10,000 miles (5000 to 16 000 km) for abnor- mal wear. Maintain the proper pressures for carried loads, per the tire manufacturers’ recommendations, or the tire pressure label on the driver’s door.

Have the wheel alignment checked after the first 10,000 miles (16 000 km), then every 40,000 miles (60 000 km) thereafter. Do not continue to drive the vehicle, get it repaired, if tires develop any of the following: blisters; cuts or punctures that reach to the cord; a nail, screw, rock, or other puncturing object; flat spots or irregular wear; tread worn to a minimum depth; inability to maintain proper tire pressure. Western Star Maintenance Manual, September 2015 40/3