Daimler Trucks North America LLC Western Star — Western Star

Brakes 42 Safety Precautions DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 42–01 Air Brake System Valve Inspection NOTE: There is no scheduled air valve mainte- nance on vehicles equipped with Bendix air valves and a Bendix air dryer if the air dryer desiccant is replaced at 350,000 miles (563 000 km).

If the desiccant is not changed at 350,000 miles (563 000 km), or if the vehicle is equipped with another air dryer, maintenance will have to be performed on the air brake valves. 07/10/2001 f422259 Fig. 1, Air Dryer Inspection 6. On the System Saver Twin only, if the compres- sor continues to run, after 50 to 60 seconds you will feel a "mini-purge", or exhaust of air, as the dryer switches cartridges. This is normal and will recur every 50 to 60 seconds as long as the compressor is running. IMPORTANT: For vehicles equipped with an oil- coalescing air dryer desiccant cartridge, replace the cartridge once a year, regardless of mileage. 42–02 Air Dryer Inspection 7.

When the air system reaches "cut-out" pressure, the dryer will purge completely. After this, the dryer will not exhaust any air until the compres- sor starts up again. 1. Park the vehicle on a level surface and apply the parking brakes. Shut down the engine. Chock the tires. 8. Shut off the engine and apply a soap solution to each connection that contains pressurized air. 2. Completely drain all air reservoirs. Air pressure gauges should read 0 psi (0 kPa). If soap bubbles do not appear, connections are sealed properly. 3. Close the drain cocks on all reservoirs. 4. Start the vehicle and allow the air system pres- sure to build while the engine idles. Note:

Some compressors may need to run above idle to build system air pressure in a rea- sonable time. If air pressure build-up is ex- tremely slow after two to three minutes, raise the engine speed to 1000 to 2000 rpm. If soap bubbles appear, drain all reservoirs and remove the leaking connection. Inspect it for damaged threads or cracks, and replace as nec- essary. Apply pipe sealant or teflon tape to the connection before re-installing it. Repeat the pro- cess until all connections are properly sealed. 5. Place your hand under the air dryer purge valve, located at the base of the dryer; see Fig. 1 . You should feel a light air flow that will continue until the air compressor unloads.

Western Star Maintenance Manual, September 2015 42/1