Fuel 47 7. Hand-tighten until the gasket is in full contact with the fuel separator, then tighten an additional 1/4 to 1/3 turn. 6 8. Check that the drain valve is tightened and closed. 5 9. To prime the fuel separator, remove the vacuum breaker fitting and fill the unit with diesel fuel, then install and close the fitting when the unit is full. 4 7 IMPORTANT: The fitting must be air-tight and the valve closed. 3 47–03 Fuel Tank Band Nut Tightening 8 IMPORTANT: Do not overtighten the nuts. 9 Rectangular Fuel Tank Hold the retention nut on the fuel tank band with a wrench while backing off the jam nut. Then tighten the retention nut 13 to 17 lbf·ft (18 to 23 N·m).
After the retention nut has been tightened, hold the reten- tion nut with a wrench while tightening the jam nut 13 to 17 lbf·ft (18 to 23 N·m). Cylindrical Fuel Tank 10 2 11 Hold the retention nut on the fuel tank band with a wrench while backing off the jam nut. Then tighten the retention nut 30 to 35 lbf·ft (41 to 46 N·m). After the retention nut has been tightened, hold the reten- tion nut with a wrench while tightening the jam nut 30 to 35 lbf·ft (41 to 46 N·m). 1 13 12 14 02/09/2011 f470568 1. Drain Valve 2. Lower Housing 3. Cover O-Ring 4. Vent Cap O-Ring 5. Vent Cap 6. Collar 7. Clear Cover 8. Spring 9. Filter Element 10. Check Valve Assembly 11. Fuel Inlet Port 12. Pre-Heater 13.
Fuel Outlet Port 14. Water-In-Fuel Sensor Fig. 6, DAVCO Diesel Pro 243 Western Star Maintenance Manual, September 2015 47/5