Doors 72 72–01 Door Seal, Door Latch, Door Hinge, and Door Check Lubrication NOTE: Light penetrating oils, such as WD–40, should not be used because they wash out ben- eficial factory-installed grease, and they evapo- rate. Door Seals Lightly coat the door seals with a lubricant that’s safe for rubber. Door Latches Wipe old grease and dirt from all door latch assem- blies, then apply liberal amounts of an approved grease to each moving joint; see Table 1 . Use an appropriate applicator that will not leave material behind. Door Hinges Lubricate external hinges every six months. Wipe old grease and dirt from the hinge, then force an ap- proved grease into the hinge components; see Table 1 .
Use an appropriate applicator that will not leave material behind. Wipe off any excess grease. Door Checks Wipe old grease and dirt from door checks. Lubricate each moving joint of the door checks at installation and every six months thereafter, with an approved grease; see Table 1 . Use an appropriate applicator that will not leave material behind. Application Lubricant NLGI Grade Approved Grease Door Latches ConocoPhillips Triton® 460 1.5 Door Checks ConocoPhillips Megaplex® XD3 2 Table 1, Approved Grease Western Star Maintenance Manual, June 2010 72/1