Daimler Trucks North America LLC Western Star — Western Star

Heater and Air Conditioner 83 Safety Precautions the clutch. For instructions, see Section 83.00, Subject 140 of the Western Star Workshop Manual . DANGER 4. Check the overall condition of the air conditioning hoses. Look for cracks, cuts, and abrasions on the hoses. Replace damaged hoses. Also check for signs of loose fittings on all of the air condi- tioning components. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death.

1 83–01 Air Conditioner Inspection 2 A WARNING Wear eye protection, gloves, and protective cloth- ing when working on the air conditioning system. Leaking refrigerant from a damaged hose or line could cause blindness or serious skin burns. 1. Park the vehicle on a level surface, apply the parking brake, and chock the tires. 01/13/2010 f831825 See Table 1 for acceptable clearances. 2. Inspect the A/C compressor hub. A torn or melted rubber dampener (center section) indi- cates internal damage has occurred within the compressor. Inspect friction surfaces for wear, oil-soaked conditions, or discoloration due to ex- cessive heat. A. Clearance 1. Hub 2. Rotor Magnetic Clutch Fig.

1, Hub/Rotor Clearance Acceptable Compressor Clutch Clearances 3. With the belt removed, check to make sure that the rotor (pulley) spins freely. It should not wobble or contact the hub when it is spinning. Using a feeler gauge, check the clearance be- tween the rotor and hub at several locations, and average the results. See Fig. 1 . See Table 1 for acceptable clearances. Compressor Acceptable Clearance: inch (mm) Denso 0.014 to 0.024 (0.35 to 0.6) Sanden 0.016 to 0.031 (0.40 to 0.78) Table 1, Acceptable Compressor Clutch Clearances Climate Control 0.020 to 0.030 (0.50 to 0.76) For a Denso compressor, if the clearance is greater than 0.024 inch (0.6 mm), replace the clutch.

For instructions, see Section 83.04, Sub- ject 140 of the Western Star Workshop Manual . 83–02 HVAC Air Filter Cleaning and Replacement For a Sanden compressor, if the drive plate clutch needs adjustment, see Section 83.01, Subject 130 of the Western Star Workshop Manual . The cab HVAC assembly has either two pleated, dust/odor air filters that are not cleanable and must be replaced every three months, or two foam air fil- ters with aluminum screens that can be cleaned every three months and replaced once a year. For a Climate Control compressor, if the clear- ance is 0.035 inch (0.89 mm) or greater, replace Western Star Maintenance Manual, September 2015 83/1