Alternators and Starters 15 Safety Precautions Battery acid is extremely harmful if splashed in the eyes or on the skin. Always wear a face shield and protective clothing when working around batteries. DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. The vehicle is equipped with an alternator charg- ing system. Make sure the polarity (+ and is correct when connecting battery cables. Revers- ing the polarity will damage the alternator. 1.
Make sure the batteries are disconnected. 15–01 Alternator and Starter Check 2. Inspect the battery cables for wear and replace as needed. Clean cable connector terminals with a wire brush. Consult your Western Star Dealer for troubleshooting, adjustment, and battery re- placement. 1. Disconnect the batteries. 2. Check the tightness of the alternator bracket fas- teners; tighten the fasteners as needed. See Group 00 for torque specifications. 2.1 Clean and tighten the battery cables, ter- minals, and clamps. 3. Check the tension of the alternator belt. See Group 01 for belt tension instructions. 2.2 Inspect the battery hold-down assembly and the battery box. Replace worn or damaged parts.
Remove any corrosion with a wire brush, and wash with a weak solution of baking soda and water. Rinse with clean water, and dry. If needed, paint the retainer assembly to prevent corro- sion. Some engines are equipped with dual alternator belts. Always check both belts for correct ten- sion. Engines equipped with a serpentine or poly-V belt have automatic belt tensioners and do not require belt tension inspection. 4. Check that all electrical connections at the alter- nator and starter are clean. Clean and tighten all charging system electrical connections as needed. 2.3 Check that foreign objects, such as stones, bolts, and nuts are removed from the battery box. 5.
Check the alternator wiring for missing insulation, kinks, and heat damage. Replace or repair as needed. 2.4 After cleaning, connect the cables to the batteries, and tighten them to the specifi- cation listed on the battery. If no specifi- cations are found, then use 10 to 15 lbf·ft (14 to 20 N·m). 15–02 Battery Check 2.5 Coat the battery terminals with dielectric grease. WARNING 3. Check the terminals on the battery shut-off switch and the magnetic switch. Make sure the terminal connections are clean and tight. Coat the terminal connections with dielectric red enamel after cleaning. Batteries generate explosive gas as a by-product of their chemical process.
Do not smoke when working around batteries. Put out all flames and remove any source of sparks or intense heat in the vicinity of the battery compartment. Make sure the battery compartment has been completely vented before disconnecting or connecting the battery cables. Western Star Maintenance Manual, September 2015 15/1 CAUTION