Daimler Trucks North America LLC Western Star — Western Star

Clutch 25 Safety Precautions DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 25–01 Clutch Release Bearing Lubrication Lubricate the release bearing as follows: 1. With the vehicle parked on a level surface, apply the parking brakes and chock the rear tires. 2. Remove the clutch inspection plate. NOTE:

For lubricating the release bearing, Eaton Fuller recommends a lithium-base grease that can operate up to at least 325°F (163·C) and meets the NLGI Grade 2 or 3 specification. f250081a 05/27/93 NOTE: Some clutch release bearings are equipped with a lubrication extension that extends outside of the clutch housing. It is not necessary to remove the clutch in- spection plate when the lubrication extension is used. Meritor recommends a lithium-base high- temperature grease that meets the NLGI Grade 3 specification. Fig. 1, Release Bearing Grease Fitting 1 3. Wipe away any dirt from the grease fitting. See Fig. 1 .

Using a pressure-type grease gun equipped with the recommended grease, lubri- cate the bearing until excess grease purges from the rear of the release bearing (toward the transmission). NOTICE 08/10/2009 f250444 2 Do not over-lubricate the clutch release bearing. Over-lubrication could contaminate the clutch in- ternally, causing clutch slippage and premature failure. Do not use chassis grease or multipurpose lubricants. 1. Sleeve Bushing Contact Point 2. Yoke Finger Contact Points Fig. 2, Grease Contact Points 25–02 Clutch Release Cross- Shaft Lubrication 4. Wipe off excess grease and apply it to both the yoke finger and sleeve bushing contact points. See Fig. 2 . 5.

Install the clutch inspection plate. The clutch release cross-shaft is equipped with two grease fittings in the transmission clutch housing. See Fig. 3 and Fig. 4 . Wipe the dirt from the grease fittings and lubricate with multipurpose chassis grease. Western Star Maintenance Manual, September 2015 25/1