Daimler Trucks North America LLC Western Star — Western Star

Frame and Frame Components 31 Safety Precautions 7. Test the secondary safety lock latch for ease of operation. DANGER 8. Check for loose nuts or bolts on the fifth wheel and the mounting. Set a torque wrench to the maximum torque value for the bolt being checked, and confirm that the torque is to speci- fication. Do not loosen the bolt to check the torque. See Group 00 for bolt torque specifica- tions. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 9.

Check all springs to see if they are securely fas- tened, and are not deformed. 31–01 Fifth Wheel Inspection WARNING WARNING Do not disassemble the fifth wheel to inspect the springs. The springs are under extreme pressure, and could cause serious injury. All fifth wheel maintenance, adjustment, and re- building must be done only by a qualified me- chanic. Improper or incomplete procedures could result in a possible disengagement of the trailer from the tractor, which could result in personal injury or property damage. 10. Check wedge adjustment. 10.1 Open the kingpin lock, and vertically in- sert a 2-inch (50-mm) diameter shaft.

10.2 Release the lock by tripping the release latch at the bottom of the throat. Parts are under spring compression. Wear safety goggles while servicing the fifth wheel. Failure to do so can result in personal injury, due to parts ejecting with force. Fontaine 10.3 Adjust the wedge stop at the end of the wedge to approximately 1/4-inch (6-mm) clearance by turning the wedge stop rod located on the right side of the top plate. 11. Replace cracked, worn, or damaged parts with new parts. Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. 1. Disconnect the tractor from the trailer.

For in- structions, see the Western Star Driver’s Manual . 2. Thoroughly steam clean the fifth wheel. 3. Check for cracks in the fifth wheel assembly, mounting brackets, and mounting parts. 12. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. Apply a generous coating of grease to the top plate to fill the grooves, or depressions, on the top plate. See MOP 31–02 for lubrication instruc- tions. 4. Ensure that both bracket pins are in place and secured by retainer pins and cotter pins. See Fig. 1 . 5. For fifth wheels equipped with bracket liners, rock the fifth wheel.

If it does not rock freely, re- move the top plate and inspect the bracket lin- ers. Replace liners that are broken or less than 0.125 inch (3 mm) thick at the top of the liners. For the liner replacement procedure, see the Fontaine website, www.fifthwheel.com . Holland FWS1 1. Disconnect the tractor from the trailer. For in- structions, see the Western Star Driver’s Manual . 2. Thoroughly steam clean the fifth wheel. 6. Check the jaw and stationary jaw for mushroom- ing, and check that the serrations at the jaw and wedge are in good condition. 3. Check the fifth wheel plate for cracks. Check for sharp edges on top; the chamfer should be 1/8 to 1/4 inch (3 to 6 mm).

Western Star Maintenance Manual, September 2015 31/1