Frame and Frame Components 31 Battery and Tool Box Brackets Engine Supports Equalizer Brackets Exhaust Brackets Fifth Wheel Legs Fifth Wheel Mounting 2 3 4 Frame Crossmembers and Gussets Front Frame Brackets Front Suspension Spring Brackets 1 Fuel Tank Brackets 11/21/95 f310371 Radius Rods 1. Rack 2. Plunger 3. Pocket 4. Plunger Adjusting Bolt Rear Engine Supports Fig. 13, Holland Fifth Wheel Sliding Mechanism Rear Suspension Spring Brackets Shock Absorbers 31–04 Frame Fastener Torque Check All Other Frame Fasteners Any component that shows signs of cracking or other damage must be repaired or replaced. Frame brackets and components are to be checked at initial maintenance (IM).
Check the torque of frame fasteners to offset the effects of "bedding in" (or seat- ing). When possible, always check the torque of the nut, not the bolt head. This will give a true torque reading by eliminating bolt body friction. When checking the torque of frame fasteners, inspect the frame for cracks and other damage. Set a click-type torque wrench to the maximum torque of the fastener you are checking. Apply pressure until the torque wrench clicks. Do not loosen the fastener to check the torque. See the applicable torque table in Group 00 for torque specifications.
31–05 Trailer Electrical Connector Lubrication In some cases, failure of trailer cables occurs due to intrusion of chloride-based road deicing chemicals into the trailer connector. Once inside the connector, the chloride-based chemicals corrode the brass ter- minals and create bridging between positive and ground terminals. NOTE: The use of soap is not recommended for cleaning the electrical connector, as some soaps may increase the corrosion process. NOTICE Make sure frame fasteners are properly tightened. Continued vehicle operation with loose fasteners could result in bracket or frame damage. 1.
Wash out any existing grease, dirt, and corrosion on the trailer connectors with electrical contact cleaner spray. NOTE: Engine supports on vehicles built from January 2007 do not require checking. 2. Grease the trailer connector with a lithium-based dielectric grease. Inspect and check the fasteners at the following locations: 31–06 Premier 690 Coupling Inspection Air Tank Mounting Brackets Axle Stops Cab Mount Brackets IMPORTANT: Before servicing the Premier cou- pling, refer to the Premier web site at Western Star Maintenance Manual, September 2015 31/9