TR-Automotive Servicing (Electrical Repair) NC II Revision 01 Promulgated (08/11/2020) 136 Unit of Competency Learning Outcomes Learning Activities Methodology Assessment Approach Nominal Duration 3.2.5 Identify PPEs 3.2.6 Discuss OSHS in using automotive tools 3.2.7 Use automotive tools 3.2.8 Use PPEs 3.3 Maintain automotive tools 3.3.1 Discuss the procedure in cleaning, checking for serviceability, and storing of automotive tools and attachments 3.3.2 Discuss the procedure in identifying and reporting defects and damages 3.3.3 Discuss the proper waste segregation 3.3.4 Demonstrate the proper maintenance of automotive tools 3.3.5 Demonstrate disposal of wastes Lecture Visual aids Videos Written examination Demonstration 4 Hours 4.
Perform mensuration and calculation 4.1 Select measuring instruments 4.1.1 Describe measuring instruments 4.1.2 Select measuring instruments 4.1.3 Inspect and calibrate measuring instruments 4.1.4 Report and return defective measuring instruments 4.1.5 Demonstrate safety practices Demonstration Video presentation Lecture Discussion Workshop visit Demonstration Written exam Oral questioning 9 Hours 4.2 Carry out measurements and calculation 4.2.1 Explain formulas for volume, areas, perimeters of plane and geometric figures 4.2.2 Explain the procedure in reading tools’ limit of accuracy Demonstration Video presentation Lecture Discussion Workshop visit Demonstration Written exam Oral questioning 29 Hours