3.2 TRAINING DELIVERY 1. The delivery of training shall adhere to the design of the curriculum. Delivery shall be guided by the principles of competency-based TVET. a. Course design is based on competency standards set by the industry or recognized industry sector; (Learning system is driven by competencies written to industry standards) b. Training delivery is learner-centered and should accommodate individualized and self-paced learning strategies; c. Training can be done on an actual workplace setting, simulation of a workplace and/or through adoption of modern technology. d.
Assessment is based in the collection of evidence of the performance of work to the industry required standards; e. Assessment of competency takes the trainee’s knowledge and attitude into account but requires evidence of actual performance of the competency as the primary source of evidence. f. Training program allows for recognition of prior learning (RPL) or current competencies; g. Training completion is based on satisfactory performance of all specified competencies. 2. The competency-based TVET system recognizes various types of delivery modes, both on-and off-the-job as long as the learning is driven by the competency standards specified by the industry.
The following training modalities and their variations/components may be adopted singly or in combination with other modalities when designing and delivering training programs: 2.1 School/Institution- Based: Dual Training System (DTS)/Dualized Training Program (DTP) which contain both in-school and in-industry training or fieldwork components. Details can be referred to the Implementing Rules and Regulations of the DTS Law and the TESDA Guidelines on the DTP; Distance learning is a formal education process in which majority of the instruction occurs when the students and instructor are not in the same place.
Distance learning may employ correspondence study, audio, video, computer technologies or other modern technology that can be used to facilitate learning and formal and non-formal training. Specific guidelines on this mode shall be issued by the TESDA Secretariat. Supervised Industry Training (SIT) or on-the-job training (OJT) is an approach in training designed to enhance the knowledge and skills of the trainee through actual experience in the workplace to acquire specific competencies as prescribed in the training regulations. It is imperative that the deployment of trainees in the workplace is TR-Automotive Servicing (Electrical Repair) NC II Revision 01 Promulgated (08/11/2020) 158