BAIC — Technical Education and Skills Development Act of 1994

TR-Automotive Servicing (Electrical Repair) NC II Revision 01 Promulgated (08/11/2020) 173 Mount/Install Suspension Drive Train Install/Fit out Trim Parts/ and Assemblies Perform Final Engine Run Perform Wheel Alignment Operations Install/Fit Out Electrical Parts to Engine Assembly Install/fit Out Electrical Parts and Electronic Units to Body Interior Compartment Install/Fit Out Electrical Parts and Electronic Units to Dash Instrument Panel Install/Fit Out Electrical Parts to Exterior and Engine Compartment Install/Fit Out Audio and Video Systems Perform Headlight Focus Aiming Operations Prepare Molds for Composites Production Prepare Materials for Formulae Assemble Materials and Equipment for Production Operate Injection Molding Equipment Operate Blow Molding Equipment Monitor Process Operations Finish Products and Components Perform Engineering Measurement Perform Precision Mechanical Measurement Calibrate Measuring Equipment Select and Control Inspection Processes and Procedures Perform Inspection Perform Basic Statistical Quality Control Use Improvement Processes in Team Activities Perform Pre-treatment and Cathodic Electro- deposition Process Operation Perform Gray Primer (2nd Primer) Application Procedures Perform Top Coat Application Procedures Weld and Braze Automotive Body Shell Perform Tinsmith Operation Melt Aluminum-Silicon Alloys for Safety Tested Castings Melt Metals Using Coreless Induction Furnace Melt Automotive Gray Iron Castings in Cupola Prepare Sand Mixture for Heavy Casting Perform Hand Molding To Produce Heavy Castings Pour Molten Metal to Heavy Castings Rectify Faults on Installed Electrical Parts to Engine Assembly Rectify Faults on Installed Electrical Parts and Electronic Units to Body Interior Compartment Rectify Faults on Installed Electrical Parts and Electronic Units to Dash Instrument Panel Rectify Faults on Installed Electrical Parts to Exterior and Engine Compartment Rectify Faults on Installed Audio and Video System to Automotive Vehicle Conduct Engine Hot Test Rectify Assembly Faults on Assembled Mechanical Assemblies Rectify Faults on Mounted/Installed Brake and Fuel System Rectify Faults on Mounted/Installed Power Drive System Rectify Faults on Mounted/Installed Suspension Drive Train Select Heat Treatment Process Perform Heat Treatment Process Change Equipment Dies Prepare and Start Equipment for Production Produce Injection Molded Products Produce Blow Molded Products Apply quality systems Conduct product and/or process capability studies Maintain/supervise the application of quality procedures Select and classify materials and parts for assembly of wiring harness Perform cutting and stripping of electrical wires Perform crimping and soldering of terminals Perform tying, taping and finishing of assembly wires Use Comparison and Basic Measuring Devices Measure Components Using Coordinate Measuring Machines