4M41 ENGINE - Turbocharger Assembly 11B-10-2 A INSTALLATION SERVICE POINT " A A TURBOCHARGER ASSEMBLY INSTALLATION (1) Prior to installing the turbocharger assembly 14 , pour engine oil into it through the oil inlet hole A to lubricate its component parts for smooth movement. (2) Using a tester, apply pressure to the actuator B and read the pressure at which the rod C begins to move (approximately 1 mm). If the reading deviates from the specified standard value, replace the actuator. C Standard value: 161 kPa B Caution Do not load the actuator B with any more pressure than 181 kPa nor carry the turbocharger by holding the rod C, or the diaphragm may be damaged. PWEE9409-D E Feb.
2000 Mitsubishi Motors Corporation Added