Mitsubishi — 18. TIMING GEAR CASE

4M41 ENGINE - Timing Gear Case 11B-18-2 REMOVAL SERVICE POINT A A " CRANKSHAFT PULLY REMOVAL Holding the crankshaft pulley 4 with the special tool, remove the bolt 2 . 4 MB990767 MD998754 INSTALLATION SERVICE POINTS " A A TIMING GEAR CASE INSTALLATION Apply an even bead of sealant to the entire joint surface of the timing gear case 13 as shown. Bead diameter: 3.5 mm. 13 Specified sealant: Mitsubishi Genuine Part No. MD970389 or equivalent Caution Squeeze out the sealant uniformly without excess and discontinuity.

A B " B A FRONT OIL SEAL INSTALLATION Apply a thin coat of engine oil to the lip C , and install the front oil seal 11 in the timing gear case 13 with the lip directed as shown until its end surface A becomes flush with the end surface B of the case. 11 13 A : End surface (front oil seal) B : End surface (timing gear case) C : Lip C PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added