4M41 ENGINE - Timing Gear and Balance Shaft 11B-19-3 2. END PLAY If the reading exceeds the specified service limit, replace defective part. Standard value: Balance shaft LH, RH 0.09 - 0.24 mm Idler gear and sprocket assembly 0.05 - 0.20 mm Idler gear LH assembly 0.05 - 0.20 mm Limit: Balance shaft LH, RH 0.3 mm Idler gear and sprocket assembly 0.3 mm Idler gear LH assembly 0.3 mm REMOVAL SERVICE POINTS A A " IDLER GEAR BUSH LH REMOVAL Using the special tool, remove the idler gear bush 25 . MH062463 25 A B " IDLER SPROCKET BUSH REMOVAL Using the special tool, remove the idler sprocket bush 43 .
MH062462 43 INSTALLATION SERVICE POINTS " A A IDLER SPROCKET BUSH INSTALLATION Using the special tool, press-fit the idler sprocket bush 43 into the idler gear and sprocket 42 from the side showing the match mark . MH062462 42 43 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added