4M41 ENGINE - Oil Cooler and Oil Filter 11B-21-2 CLEANING (1) Check the oil cooler element 5 for deposited carbon and sludge in oil passage and bypass, and wash it clean in cleaning oil, if necessary. (2) Wash the oil cooler element 5 and the oil cooler body 13 if they are much contaminated with scale. INSPECTION OIL COOLER ELEMENT (1) Immerse the oil cooler element 5 in a water tank, with the oil outlet A closed. Connect a hose to the engine oil inlet B . (2) Apply an air pressure of 1470 kPa into the oil cooler element 5 through the connected hose, and check for air leaks. (3) Replace the oil cooler element 5 if it leaks.
A B INSTALLATION SERVICE POINT " A A OIL FILTER INSTALLATION (1) Clean the surface of the oil cooler assembly 2 which contacts the oil filter 1 . (2) Apply a thin coat of engine oil to the gasket A on the oil filter 1 . (3) Holding the gasket A in contact with the oil cooler assembly 2 , tighten the cover 5/8 turn. 2 A 1 MH061590 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added