Mitsubishi — 22. OIL PAN, OIL STRAINER AND OIL JET

4M41 ENGINE - Oil Pan, Oil Strainer and Oil Jet 11B-22-2 B INSTALLATION SERVICE POINT " A A OIL PAN INSTALLATION (1) Apply sealant at the bottom B of the mating surface of lower crankcase C and timing gear case D . C B D (2) Apply even beads of sealant A without skips to the circumferential mating surface of the oil pan 6 as shown. Bead diameter: f 3.5 ± 1 mm Specified sealant: Mitsubishi Genuine Part No. MD970389 or equivalent. A 5 6 A (3) Install the oil pan 6 to the lower crankcase within 15 minutes after the application of sealant A . f 3.5 ± 1 mm Caution 1. The surface to be coated with sealant A must be clean and free of slush and other foreign matters. 2.

When installing, take care that sealant A does not smear other places. 3. After the oil pan 6 is installed, wait for at least one hour before starting the engine. 4. Remove and reinstall the oil pan 6 with fresh beads of sealant A whenever the bolts 5 (holding the oil pan) were loosened or removed after the installation. PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added