4M41 ENGINE - Crank Shaft and Crank Case 11B-25-2 Removal steps 1. Bolt " F A 2. Front plate 3. Stiffener 4. Stiffener RH 5. Stiffener LH 6. Bolt 7. Rubber spacer 8. Dust cover 9. Rear plate 10. Bolt " E A 11. Rear oil seal " E A 12. Rear oil seal case 13. Bolt 14. Main cap bolt A A " " D A 15. Lower crankcase assembly " A A 16. Lower main bearing 17. Lower crankcase " B A 18. Lower thrust plate 19. Crankshaft assembly A B " " C A 20. Crankshaft gear 21. Key 22. Crankshaft " B A 23. Upper thrust plate 24. Upper crankcase assembly " A A 25. Upper main bearing 26. Check valve 27. Oil jet 28. O-ring 29. Upper crankcase Caution 1.
The lower crankcase 17 and upper crankcase 29 have been machined in a pair. Therefore, replacing either one of the pair is not allowed. 2. The front plate 2 is held in position with the idler shaft, in addition to locating pin. 3. The main cap bolt 14 is tightened to a plastically deformed point. If it shows the evidence of having been tightened three times, replace it. 4. Do not remove the crankshaft gear 20 unless absolutely necessary. PRE-REMOVAL INSPECTION CRANKSHAFT Before removing the lower crankcase assembly 15 , measure the end play of the crankshaft assembly 19 . If the reading exceeds the specified limit, replace the thrust plate 18 , 23 with an oversize one. Standard value:
0.10 - 0.28 mm Limit: 0.4 mm oversize thrust plates> +0.15 mm, +0.30 mm, +0.45 mm REMOVAL SERVICE POINTS 4 8 9 12 13 16 1 5 A A " LOWER CRANKCASE ASSEMBLY CREMOVAL (1) Gradually loosen the bolts 13 in the sequence of numbers 1 - 16 shown in the illustration. (2) Then, gradually loosen the main bearing cap bolts 14 in the sequence of numbers 17 - 26 shown, and remove. 20 24 26 21 17 18 22 25 23 19 2 3 6 7 10 11 14 15 A B " CRANKSHAFT GEAR REMOVAL Using the special tool, remove the crankshaft gear 20 . MH062469 A Caution 1.
Before attaching the special tool, install a protective bolt A (M16 x 1.5 mm ; 30 mm long) to the crankshaft end so that the crankshaft will not be damaged by the special tool. 2. Do not tap on the crankshaft gear 20 to remove it. 20 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added