Engine Operation - Except 4.5L Engines IMPORTANT: DO NOT add makeup oil until the oil level is BELOW the ADD mark on dipstick. John Deere ENGINE BREAK-IN OIL (TY22041) should be used to make up any oil consumed during the break-in period. RG8028A –UN–15JAN99 Crosshatch Pattern On Dipstick 3. Check engine oil level more frequently during engine break-in period. If oil must be added during this period, John Deere ENGINE BREAK-IN OIL is preferred. See ENGINE BREAK-IN OIL, in Fuels, Lubricants, and Coolant Section. A—Crosshatch Pattern On Dipstick IMPORTANT:
DO NOT use PLUS-50 Engine Oil or engine oils meeting API CG4, API CF4, ACEA E3, ACEA E2, API CI-4, ACEA E5, API CH-4 or ACEA E4 performance levels during the first 100 hours of operation of a new or rebuilt engine. These oils will not allow a new or rebuilt engine to break-in properly. DO NOT fill above the crosshatch pattern (A) or the FULL mark, whichever is present. Oil levels anywhere within the crosshatch are considered in the acceptable operating range. Specification Engine 1 —Oil Pressure at Full Load Rated Speed 345 ± 103 kPa (3.45 ± 1.03 bar) (50 ± 15 psi) ................................. Minimum Oil Pressure at 850 rpm 105 kPa (1.05 bar) (15 psi) .................
Coolant Temperature Range 82 ° ° C (180 ° –202 ° F) ................................ 1 At normal operating temperature of 115 ° C (240 ° F) oil sump. Continued on next page OURGP11,0000135 –19–20NOV03–2/4 19-2 021604 PN=100