MACHINE OPERATIONS AND CONTROLS Do not use the machine in high-temperature areas, such as areas where there is burning wood, steel plates that have been left under the hot sun, or places where asphalt has been laid. Do not move the machine with the crawler on one side raised using the work equipment. This will cause dam- age to the rubber shoes and may cause the rubber shoes to come off. When the rubber parts of the road liner are so worn or broken that the head of the mounting bolts are scratched, replace the shoe immediately. If the bolt heads are broken, the bolt cannot be removed. When installing road liners, always install them to all links on both sides.
If they are installed to only one part of the links, their durability will be greatly reduced. LONG LIFE OPERATIONS Be careful of the following points when carrying out work. Avoid carrying out counterrotation turns on concrete surfaces. There is danger that the concrete surface will scrape off the rubber from the shoe. Avoid making sudden changes in direction. This may cause premature wear or damage to the rubber shoes and road liners. Avoid operating the steering when traveling over places where there is a big difference in height.
When traveling over obstacles or places where there is a difference in height, drive the machine at right angles to the obstacle to prevent the shoes from coming off. If the machine has been raised using the bucket, lower it slowly. Avoid doing work with materials that produce oil when crushed (soya beans, corn, or remains of vegetables squeezed for oil); or wash the machine after use. Avoid handling materials that will attack the adhesion of the steel core, such as salt, ammonium sulphate, potas- sium chloride, potassium sulphate, or calcium superphosphate; or wash the machine after use. The adhesion of the core will be attacked by salt, so avoid using the machine in coastal areas.
When handling salt, sugar, wheat, or soya beans, if there is any deep cut in the rubber shoes and road liners, these substances may get into the lugs or cut portion of the rubber. Always repair the rubber before use. Do not carry out work that involves scraping against walls or concrete embankments. Rubber shoes and road liners slip extremely easily on snow or frozen roads. Be careful not to slip when traveling or working on slopes. The properties of rubber shoes and road liners change when working in extermely cold places, and this will re- duce the life of the rubber shoes and road liners.
Because of the properties of rubber, use the rubber shoes within a range of -25°C to +55°C (-13°F to +131°F). Because of the properties of rubber, use the road liners within a range of -25°C to +65°C (-13°F to +149°F). When carrying out bucket operations, be careful not to damage the rubber shoes and road liners with the bucket. Always maintain the rubber shoes at the proper tension to prevent them from coming off. If the tension is low, the rubber shoes will come off under the following conditions. Even if the tension is correct, be extremely careful when carrying out operations. 129