Komatsu — 4.9.4.c CHECK ENGINE VALVE CLEARANCE, ADJUST

MAINTENANCE PROCEDURE 4.9.4.b CHANGE OIL IN FINAL DRIVE CASE The parts and oil are at high temperature immediately after the engine is stopped, and may cause seri­ ous burns. Wait for the temperature to go down before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare a container to catch drained oil. Prepare a hexagon wrench. 1. Set so that plug (G) is at the top, with plug (G) and plug (P) perpendicular to the ground. 2. Set the container to catch oil under plug (P). 3. Using a hexagon wrench, remove plugs (P) and (G), and drain the oil. 4. Tighten plug (P). 5.

Add the replacement amount of oil through the hole of plug (G). 6. When oil comes out from the hole of plug (G), install plug (G). 4.9.4.c CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, you shall request Komatsu Utility Dealer for serv- ice. 200 WARNING