Komatsu — 3.3.1.2 CHECKS BEFORE STARTING

MACHINE OPERATIONS AND CONTROLS CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL Engine parts and oil are at high temperature immediately after the engine is stopped, and will cause seri- ous burns. Wait for the temperature to cool down before starting the operation. When carrying out inspection and service inside the engine rear cover, always open the cover fully until it is secured in position by the rod. If the machine is at an angle, reposition it to level before checking. When checking the oil level after the engine has been operated, allow the engine to cool for 15 minutes before checking. 1. Open the engine rear cover. 2. Remove dipstick (G) and wipe the oil off with a cloth. 3.

Completely insert dipstick (G) into the oil filler pipe, then remove it and check the oil level. 4. The oil level should be between the H and L marks on dip­ stick (G). If the oil level is below the L mark, add oil through oil filler (F). 5. If the oil is above the H mark, drain the excess engine oil from drain plug (P), and check the oil level again. NOTE An undercover is installed on the PC35MR, so remove the undercover before starting the operation. 6. If the oil level is correct, tighten the oil filler, then close the engine rear cover. NOTE Install the undercover on the PC35MR. 91 WARNING CAUTION