MACHINE OPERATIONS AND CONTROLS 5. Extend the boom, arm, and bucket cylinder fully as shown in the diagram on the right, remove the oil filler cap, then install the cap and pressurize the inside of the tank. IMPORTANT Be sure to pressurize the hydraulic tank. If it is not pres surized, the pump will suck in air, and this will adversely affect the equipment. CHECK DUST INDICATOR 1. Open the engine rear cover and cooling cover. For de tails, see Section "3.2.10 COOLING COVER". 2. Check that the red piston has not appeared in the trans parent portion of dust indicator (1). 3. If the red piston has appeared, clean or replace the ele ment immediately.
For details of the method of cleaning the element, see "4.9.1.a CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT". 4. After checking, cleaning, and replacing, press the knob of dust indicator (1) to return the red piston to its original po sition. CHECK WATER SEPARATOR If red ring (1) of the water separator is at the bottom of case (2), there is no water. If the ring (1) is floating, there is water up to the bottom of the ring, so drain the water as follows. 1. Open the engine rear cover and cooling cover. For de tails, see Section "3.2.10 COOLING COVER". 2. Set handle (3) to CLOSED position (A). 3.
Loosen drain plug (4), drain the accumulated water until red ring (1) reaches the bottom, then tighten plug (4). 4. Set handle (3) to OPEN position (B). 5. Drain any water or sediment from the fuel tank. For de tails, see "4.9.1.e DRAIN WATER AND SEDIMENT FROM FUEL TANK". 94