. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING may cause burns. Wait for the NOTICE If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. For details, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out maintenance. REMARK 13. Check for oil leakage and wipe off any spilled oil. 4 - 70 temperature to go down When removing the oil f iller cap, turn it slowly to release th e internal pressure , then remove it 1. Set the machine to posture shown on the right, lowe r the work equipment to the gr ound, then stop the engine.
t the top of the hydraulic tank. 2. Remove the cover a 3. Remove the cap fr pressure. 4. Loosen 4 bolts, the cover may fly out u cover down when re 5. After removing sprin g (2) and valve (3), take out ele 6. Clean the removed 7. Install the new elem ent in the place where old eleme nt (4) was installed. ring (2) on top of the element. 8. Set valve (3) and sp 9. Set cover (1) in posi tion, push it down by hand, and install the cover with the moun ting bolts. ap, then install the cover at the top of the art the engine according to "STARTING 10. Install the oil filler c hydraulic tank. 11. To bleed the air, st TARTING ENGINE (PAGE 3- minutes. 12. Stop the engine.
129)" and run the engine at low idle for 10 Operate the machine af ter halting for more than 5 minu tes to eliminate bubbles in the