CONTROLS - Heating and Air Conditioning desired position as indicated by the graphics. 5. Select the recirculation button for FRESH or RECIRC air. The temperature of the air from the vents will fluctuate as the vehicle works to achieve the chosen cab temperature. When idling for short periods of time, keep the fan ON and set the air mode to FRESH air. For vehicles with a sleeper, the cab control can be used to activate/deactivate the sleeper HVAC using the button inside the mode dial. NOTE The system will remain in automatic mode until the driver adjusts the dials on the control.
Adjust the temperature knob and the system will respond to obtain the selected comfort level as quickly as possible. Fan Control Dial must also be in the ON position for A/C to be on. A/C en- gages automatically in AUTO, defrost and floor/defrost. 3 The air conditioner defaults to Manual mode when turned on. The fan speed, air temperature, and air outlets are selected using the dials on the controller. 1. To adjust the fan speed, turn the fan control dial clockwise to increase speed or counterclockwise to decrease speed. Setting the fan dial to "O" turns the HVAC system off. 2. To adjust the temperature setting, turn the temperature control dial to the desired temperature.
The system automatically adjusts the outlet air temperature to achieve the desired cab temperature. 3. Push the snowflake button if the air temperature needs to be colder, this button will manually turn on the compressor. 4. To adjust the air distribution, turn the air distribution dial to the What is Auto Mode for the Air Conditioner Setting the air conditioner for automatic temperature control. The cab temperature is set using the temperature control dial. The operating range is 60°F (16°C) and 84°F (28°C). Adjustments of 2° increments. The AUTO function uses a sun light sensor to measure the amount of sunlight entering the cab.
This sensor is located at the base of the windshield on the driver’s side of the instrument panel. Do not block this sensor. The Auto Mode will manipulate the air distribution, air temperature, fan speed, A/C compressor, and cab air recirculation to achieve the comfort level selected on the temperature dial. Depending on the specific environmental conditions, the air temperature can be slightly higher or lower than the set point. This is a normal function of the AUTO mode and is not to be mistaken for a malfunctioning system. The button that enables automatic mode is labeled AUTO . 116 Y53-6047-2HEN (03/18)