PACCAR 579, 567 — Engine Warm Up

DRIVING - Starting and Warming Up to turn the ignition on. If the engine is not started within the 6 minute timeframe, the operator will have to re-enter the passcode to start the engine. properly grounded AC electrical source. Do not start the engine with the heater plugged in. Engine, Under Hood Air Intake This switch opens a door in the engine air filter housing so that the air is taken from under the hood instead of outside air. This switch can be useful when starting the vehicle in cold weather conditions. WARNING Tips to Remember When Starting Vehicle in Cold Weather In cold weather, fast engine starting helps relieve the loads on the electrical system and cranking motor.

Using the special cold starting equipment will help starting. Engine block heaters can cause fires which may result in death, injury and/or property damage if not properly maintained and operated. Regularly in- spect the engine block heater wiring and connector for damaged or frayed wires. Do not use the heater if there are any signs of problems. Contact your authorized dealer or the manufac- turer of the heater if you are in need of repairs or information. 4 If you follow a few simple guidelines, you will extend the service life of your engine: Keep the electrical system in top condition. Use the best quality fuel of the recommended grade. Use recommended engine lubricating oil.

For manual transmissions and auxiliary transmissions, leave the transmission in neutral and allow the transmission lubricating oil to warm up (approximately 3-5 minutes) before operating vehicle. CAUTION Only operate the under hood intake air switch when outside temperatures are below 32° F (0° C). Engaging the un- der hood air intake while temperatures are above freezing may result in en- gine damage. CAUTION Always unplug heater before starting the engine. Damage to the cooling system could occur if the heater is not turned OFF (unplugged).

Engine Warm Up The purpose of engine warm-up is to allow oil film to be established between pistons and liners, shafts and bearings while your engine gradually reaches operating temperature. Depending on engine make, when the temperature falls below -10°F (-24°C), the block heater is required. Engine Block Heater (Optional) To preheat the engine before starting, plug the optional engine block heater into a 130 Y53-6047-2HEN (03/18)