DRIVING - Engine Operations does not pass the ‘rationality check.’ The instrument cluster will prompt you to press the service brake pedal if it has not been pressed since the vehicle has been started. In vehicles with Eaton transmissions, the cruise control switches may be located on the shift control knob. Press the + button on the Right Steering wheel pod if available. Press the SET portion of the SET/RESUME button on the dash 2. To decrease speed: Press the - button on the Right Steering wheel pod if available. Press the RESUME portion of the SET/RESUME button on the dash 2. Accelerate the vehicle via accelerator pedal to the desired cruise speed. 3.
Press the "SET" button to set the cruise speed. How to Use Set Cruise Control Speed When Driving Information on using the cruise control. 4 This vehicle may have cruise control switches located on the steering wheel instead of the switches on the dash board. The instructions are still the same. these instructions do not apply to Adaptive Cruise Control. While the buttons are also used to control PTO operations, these instructions are specifically for vehicle speed. The vehicle speed must be greater than 19 mph (30 kph) for PACCAR powered vehicles or 30 mph (49 kph) for Cummins powered vehicles and the engine speed must be over 1,100 rpm for the cruise set speed to work.
To Set the Cruise Speed 1. Turn the cruise function on by using the ON/OFF button The cruise icon will appear in the instrument panel display. NOTE Cancelling and Resuming Cruise Control At times the operator will need to override cruise control and take over. Cruise Control may not hold the set speed going down hills. If the speed increases going down a hill, use the brakes to slow down. This will cancel Cruise Control. There are three ways to cancel the set speed in cruise control: 1. Tap the brake pedal 2. Tap the clutch pedal 3.
Turn the cruise control system off (ON/OFF button on steering wheel or the CANCEL button on the dash) Using the brake or clutch pedal to cancel set speed allows the operator to use the RESUME feature. Pressing the RESUME button will resume the vehicle speed previously set. The cruise set speed will appear in the instrument panel display. How to Change Cruise Set Speed Once the cruise set speed is set, the operator can push certain buttons to increase or decrease speed. The vehicle cruise control must be on and the cruise speed engaged. 1. To increase speed: 136 Y53-6047-2HEN (03/18)