PACCAR 579, 567 — Air Filter Restriction Indicator

DRIVING - Engine Operations PCC Behavior There are many factors that may influence or prevent a PCC event from occurring. For example, a truck (without a trailer) may encounter fewer PCC events than a truck with a trailer. If your vehicle has the Driver Performance Assistance (DPA) and you have not used PCC for a long period of time, the DPA may advise turning PCC ON to improve fuel economy. If the vehicle enters an area that is not identified in the system's map, it will revert to normal cruise control behavior until the vehicle enters known map areas. If the system detects a problem with its software, its map, terrain, and vehicle position then it will display a fault to the operator.

If a fault it detected, please seek the service of an anuthorized dealer. If you need to access the system's software version, please use the menu control switch to navigate to the TRUCK INFO > PCC > within this menu you can find PCC Soft Vers and PCC Map Vers . As the filter plugs and restriction increases, a red indicator will appear in a window on the indicator. When red appears, the air filter should be replaced. The indicator can be reset by pressing the button at the end of the indicator. As the vehicle approaches the top of a hill, PCC will decrease the vehicle speed to avoid overshooting the set-speed, in order to avoid unnecessary acceleration on the downward slope.

This will result in a smoother, more fuel efficient ride to the top. Once over the crest, momentum takes over and the system will allow a predetermined amount of speed over the set-speed. If the driver has activated the vehicle’s Auto Retarder function, the vehicle speed may increase until it reaches the set- speed. If the vehicle drops outside the speed range, normal cruise control will accelerate the vehicle back to the minimum allowable speed. If the vehicle is equipped with Adaptive Cruise Control (ACC) and senses traffic slowing, it will overrule PCC and slow the vehicle. This event will cancel PCC. To resume the set speed, press the "SET/RESUME" button.

As the vehicle reaches flat ground after the hill, PCC will maintain the set-speed until the crest of the next hill. If you are in an area where there is no road data, the GPS signal is lost, or there is a system fault, the vehicle will revert to normal cruise control at the same cruise speed that was selected for PCC. 4 Air Filter Restriction Indicator General information about the engine air filter restriction indicator. An Air Filter Restriction Indicator is installed on the air cleaner or air induction piping so it has access to clean filtered air. 140 Y53-6047-2HEN (03/18)