PACCAR 579, 567 — How to Check for Air System Leaks

MAINTENANCE - How to Check for Air System Leaks Replace worn seals in valves and air motors as they are needed. Your authorized dealer carries rebuild kits for most units. death, personal injury,equipment or property damage. 1. Build up air pressure in the system to the governor cutout point or until 120 psi (827 kPa) is reached. 2. Stop the engine and release the service brakes. 3. Without applying the brake pedal, observe the rate of air pressure drop. This rate should not exceed 2.0 psi (14 kPa) per minute. 4. Start the engine and build up the air pressure again. 5. Stop the engine, and apply the brakes fully. Apply the brake pedal and hold it down for five minutes.

The pressure drop should not exceed 3.0 psi (21 kPa) per minute. 6. If you detect excessive leakage (air pressure loss greater than 3.0 psi (21 kPa) after five minutes of brake application), a leakage test should be made at the air line connections and at all air brake control units. These tests should determine where air is escaping. How to Check for Air System Leaks Use these steps if the air gauges in the dash or any warning lights turn on that indicate that a air leak exists in the system. Checking for air leaks should also be done after any service or repair has been done to the air system.

5 To eject moisture from the air system tanks, pull the line that is connected to the moisture ejection valve. Continue pulling until the air comes out free of water. Daily The supply and service air tanks, must be drained on a daily basis. Operate air devices daily to circulate lubricants within the unit. WARNING Do not operate the vehicle if leakage in the air system is detected. Conduct the following procedure and contact an authorized dealer (or any other proper- ly equipped service center) if a leak is detected.

Failure to check the brakes or follow these procedures could cause a system failure, increasing the risk of an accident and may result in Periodically Clean filter screens ahead of the valves by removing the screens and soaking them in solvent. Blow them dry with pressurized air before reinstalling them. Maintain the air compressor to prevent excessive oil bypass. 212 Y53-6047-2HEN (03/18)