PACCAR 579, 567 — Safety Restraint System - Inspection

MAINTENANCE - Safety Restraint System - Inspection 7. Mounting hardware for corrosion, proper tightness of bolts and nuts. 8. Web for deterioration, due to exposure to the sun. Factors contributing to reduced seat belt life: Heavy trucks typically accumulate twice as many miles as the average passenger car in a given time period. Seat and cab movement in trucks causes almost constant movement of the belt due to ride characteristics and seat design. The constant movement of the belt inside the restraint hardware and the potential for the belt to come in contact with the cab and other vehicle parts, contributes to the wear of the entire system.

Environmental conditions, such as dirt and ultraviolet rays from the sun, will reduce the life of the seat belt system. Due to these factors, the three-point safety belt system installed in your vehicle requires thorough inspection every 20,000 miles (32,000 km). If the vehicle is exposed to severe environmental or working conditions, more frequent inspections may be necessary. Any seat belt system that shows cuts, fraying, extreme or unusual wear, significant discoloration due to UV (ultraviolet) exposure, abrasion to the seat belt webbing, or damage to the buckle, latch plate, retractor hardware or any other obvious problem should be replaced immediately, regardless of mileage.

examined to determine if it is coming into contact with any sharp or rough surfaces on the seat or other parts of the cab interior. These areas are typical places where the web will experience cutting or abrasion. Cuts, fraying, or excessive wear would indicate the need for replacement of the seat belt system. 2. The pillar web guide (D-loop) is the area where almost constant movement of the seat belt webbing occurs because of relative movement between the seat and cab. 3. Check the Komfort-Latch for cracks or possible damage and check for proper operation. 4. Check buckle and latch for proper operation and to determine if latch plate is worn, deformed, or damaged. 5.

Inspect the retractor web storage device, which is mounted on the floor of the vehicle, for damage. The retractor is the heart of the occupant restraint system and can often be damaged if abused, even unintentionally. Check operation to ensure that it is not locked up and Inspection Guidelines Follow these guidelines when inspecting for cuts, fraying, extreme or unusual wear of the webbing, and damage to the buckle, retractor, hardware, or other factors. Damage to these areas indicates that belt system replacement is necessary. 5 WARNING Replace the entire belt system (retrac- tor and buckle side) if replacement of any one part is necessary.

Unexposed damage to one or more components could prevent the system from func- tioning properly the next time it is needed. Failure to comply may result in death or personal injury. 1. Check the web wear in the system. The webbing must be closely 222 Y53-6047-2HEN (03/18)