PACCAR 579, 567 — Install Engine Belt

MAINTENANCE - Engine Maintenance These references are for pipes and hoses in the engine area. 5 to check your belts frequently and replace them as soon as you detect trouble. Follow this procedure to install an accessory drive belt: 1. Route the new belt around the pulleys, and then rotate the automatic tensioner so that the idler pulley swings toward the belt routing. The following figure shows an example of the rotation direction to release the tensioner. Install Engine Belt You can extend the reliability and service life of your vehicle's drive belts with proper attention to installation, and maintenance. Neglect could cause belt failure.

The result could be the loss of the electrical or air system as well as possible engine damage from overheating. So it's a very good idea NOTE See the engine manufacturer's opera- tor's manual for further information on replacing engine drive belts. 240 Y53-6047-2HEN (03/18) Application Type of Clamp in-lb N•m Radiator and Heat Exchanger Hoses Constant Torque CT-L 10.2-12.5 90-110 Heater Hoses Constant Tension not required not required Air Intake Pipes Hi Torque HTM-L 11.3-14.2 100-125 Plastic Air Intake Pipes Constant Torque CT-L 4.5 40 (maximum) Charge Air Intake Hoses Flex Seal 7.9-11.3 70-100 B9296 6-7 50-60 Fuel, Oil and Water Heat Exchangers (for hoses less than 9/16" diameter).

Miniature 3600L 1.1-1.7 10-15