PACCAR 579, 567 — Noise and Emission Control

MAINTENANCE - Noise and Emission Control 5. Replace filter in housing taking care to align the airflow direction that is indicated on the side of the side of the filter element with the airflow direction that is clearly marked on the air intake housing. 6. Replace the filter cover on the air intake housing and slide the cover forward in vehicle. An audible snap sound can be heard when the cover is correctly in place. If the snap feature is damaged there are two screw features that may be utilized to retain the cover in place. 7. Close and secure hood of vehicle. 1. Lift the sleeper bunk to expose the sleeper HVAC module. 2.

Find the retention tab at the side of the filter element and move it to release the filter. Moving this tab will allow the filter to be removed in an upward direction. 3. Align the airflow direction that is indicated on the side of the filter element such that it points into the HVAC housing. 4. Insert the filter and make sure the retention tab has re-engaged to secure the filter. 5. Close the bunk. these components need to be functional and properly maintained.

Peterbilt warrants to the first person who purchases this vehicle for purposes other than resale and to each subsequent purchaser that this vehicle as manufactured by Peterbilt, was designed, built and equipped to conform at the time it left Peterbilt's control with all applicable U.S. EPA Noise Control Regulations. This warranty covers this vehicle as designed, built and equipped by Peterbilt, and is not limited to any particular part, component or system of the vehicle.

Defects in design, assembly or in any part, component or system of the vehicle as manufactured by Peterbilt, which, at the time it left Peterbilt's control, caused noise emissions to exceed Federal standards, are covered by this warranty for the life of the vehicle. Noise Emission Warranty 5 Replace the Recirculation Air Filter Please contact an authorized dealer when the service interval is required to inspect the cabin recirculation air filter. Noise and Emission Control Sleeper HVAC Air Filter The sleeper recirculation filter is located under the sleeper bunk on the passenger side of the vehicle. Lift the bottom bunk to access the unit. The filter can be replaced without using any tools.

Information about the federal law prohibitaing tampering with the noise and emissions systems. There are specific components on the vehicle that are designed to meet certain Environmental Protection Agency (EPA) emissions and noise regulations. To maintain conformance with the regulations, Tampering with Noise Control System Federal law prohibits the following acts or the causing thereof: 1. The removal or rendering inoperative by any person other than for purposes of maintenance, Y53-6047-2HEN (03/18) 253