MAINTENANCE - Rear Axle and Suspension gasket; replace gasket if necessary. Check cap screws for tightness, including those at the flanges. Refer to the engine manufacturer's service manual for proper tightening sequence and torque values. Joints and Clamps Check for leaks, and tighten as necessary. Check for deterioration or dents in pipes and clamps which could allow exhaust to escape. Replace any serviceable joints, flexible pipes and gaskets at the service intervals. Selective Catalysts Reduction (SCR) Check SCR canister filter, clamps and mounting brackets. Tighten if necessary. Inspect SCR canister for signs of rust or corrosion.
Exhaust Piping Check exhaust piping for rust, corrosion, or damage. Replace deteriorated piping before holes appear. If piping is perforated at any point, temporary patching or lagging is acceptable until you can have permanent repairs made. On turbocharged engines, check joints at flanges and mounting brackets for tightness. Diesel Particulate Filter (DPF) Check diesel particulate filter (DPF), clamps, and mounting brackets. Tighten if necessary. Inspect diesel particulate filter (DPF) for signs of rust or corrosion. Check internal baffling.
You can do this by listening for rattling sounds while tapping on the diesel particulate filter (DPF) with a rubber mallet or revving the engine up and down through its normal operating range. Diesel Exhaust Fluid Tank (See Aftertreatment System manual.) Exhaust Tail Pipe Engine Fan and Shroud Hood Insulation Blanket Inner Fenders Shields and Cab Skirts CAUTION Air leaks cause excessive noise and may result in serious damage to the engine. If you do not repair them the engine damage will not be covered by your warranty. Repair all air leaks as soon as you find them. Engine Mounted Noise Insulators Check condition. Is the insulator secure?
How you do this will depend on the method of attaching the noise insulators on the engine and around the oil pan (bolts, snap fasteners, or straps). Tighten loose fasteners and repair or replace any worn or damaged fasteners. Check insulators around fasteners and stress points, especially where they may be affected by engine vibration. Repair any cracked or damaged mounting points. Use suitable reinforcing plates to ensure that the insulators will remain in position. Exhaust System Check for exhaust leaks, which would indicate a leaking manifold 5 Rear Axle and Suspension Maintenance requirements for rear axle suspension.
Your vehicle's suspension, by design, requires a minimal amount of maintenance. Y53-6047-2HEN (03/18) 255