PACCAR 579, 567 — Rear Axle Lubrication

MAINTENANCE - Rear Axle and Suspension life, replace the complete assembly if cracks or other defects are detected. After replacement of any part or discovery of loose components, check the torque of all fasteners. New springs settle-in after the vehicle's initial service, causing the U-bolts to become loose. Rear Suspension U-Bolts Load the vehicle to its normal gross weight before tightening U-bolts. Loading the vehicle ensures proper adjustment of the U-bolt and spring assembly. NOTE To ensure an accurate torque reading, use properly maintained and calibrated torque wrenches. Clean the nut and bolt. No dirt, grit, or rust should be present.

WARNING Do not replace U bolts and nuts with common U bolts or standard nuts. These parts are critical to vehicle safe- ty. If the wrong U bolts or nuts are used, the axle could loosen or sepa- rate from the vehicle and cause a seri- ous accident. Use only U bolts and nuts of SAE Grade 8 specification or better. Failure to comply may result in death, personal injury, equipment or property damage. Rear Suspension Fasteners To maintain the performance of the air suspension, check fastener torque values after the first 2,000 miles (3,218 km) of service and every 60,000 miles (96,000 km) thereafter. Torque recommendations apply to fasteners supplied and installed by vehicle manufacture.

The values listed in the at the back of this chapter (Specification Reference Charts), are for cadmium plated or phosphate and oil fasteners only. U-bolts are difficult to tighten unless you have the right equipment. If you cannot tighten them correctly yourself, be sure to have them checked and tightened regularly by an authorized mechanic. WARNING 5 Do not operate the vehicle if the sus- pension U bolts are not properly tight- ened. Loose U bolts will cause the axle to not be properly secured to the suspension, which could cause loss of vehicle control and an accident. Loose U bolts can also cause uneven tire wear and poor alignment.

Failure to comply may result in death, personal injury, equipment or property damage. Related reference Rear Axle Lubrication Lubrication requirements for rear axles. See the axle manufacturer's operator's manual for lubrication specifications and service intervals. Check oil level with the vehicle parked on level ground and the fluid warm. The level NOTE Whenever possible, torque all frame fasteners on the nut end, not the bolt head. Y53-6047-2HEN (03/18) 257