PACCAR 579, 567 — Pipe and Hose Clamp Torque Values

MAINTENANCE - Specification Reference Charts the fluid, locate the drain fitting on the air solenoid mounted to the transmission housing. Open this fitting and allow fluid to drain out of the system. Once all the fluid is drained out, close the fitting and fill the system through the master cylinder reservoir in the engine compartment. Once the system is full, then purge the system of air by simultaneously pressing on the pedal and opening the fitting to allow air to escape. Close the fitting when fluid starts coming out. Then refill the reservoir. Repeat this until all air has been purged from the system. Replace with the recommended fluid per Lubrication Specification Chart on page 270.

Clutch Adjustment manufacturer's Service Manual for the proper adjustment procedures. Some clutches are self-adjusting, however; there are manually adjusted clutches that will require the operator to know when to adjust the clutch. The clutch will need adjustment when your clutch pedal stroke seems to get longer and its effectiveness at a seamless shift becomes less. Another sign of the clutch needing adjustment is the level of the fluid in the reservoir. If the hydraulic fluid is not leaking, but the fluid level is getting lower, then the clutch may need to be adjusted. Please take the vehicle to an authorized dealership to have the clutch adjusted.

See the clutch Specification Reference Charts Pipe and Hose Clamp Torque Values Torque specifications for engine parts. 5 These references are for pipes and hoses in the engine area. 268 Y53-6047-2HEN (03/18) Application Type of Clamp in-lb N•m Radiator and Heat Exchanger Hoses Constant Torque CT-L 10.2-12.5 90-110 Heater Hoses Constant Tension not required not required Air Intake Pipes Hi Torque HTM-L 11.3-14.2 100-125 Plastic Air Intake Pipes Constant Torque CT-L 4.5 40 (maximum)