Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *1: When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. When using corrosion resistor, use Komatsu genuine corrosion resistor. If you use another corrosion resistor, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. The coolant has the important function of preventing corrosion as well as preventing freezing.

Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum.

To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system.

The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F). Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F). 4 - 27 Immed iately after the engin e is stoppe d, the engine co olant is hot and the p ressure inside the sub-tank is high. Removing the cap an d draining t he water under this condition could cause burn s. A llow the engine to cool down , then turn the cap slowly to relea se the pres sure. Start th e engine an d flush th e system. When standing up or leavin g the operator's s eat , se t the shift l ever t o the N position and set the parking bra ke switc h to the PA RKING position .

For det ails of start ing the e ngine, see "OPERATIONS , CHECKS B EFORE STARTING (PAGE 3-85)" and " STARTING ENGINE (PAGE 3-86)" in th e OPERATION secti on of the Operat ion and Maintenanc e Manual When t he underco ver is removed, ther e is danger of t ouching the fan. Never go to the fro nt of the machine w hen the engine is running. Stop the machine o n level ground w hen cleaning o r changing the coolant. Clean th e inside of the cooling syste m, change the coolant a ccording to the table below.

Interv Antifreeze coolant al for cleaning inside of cooling system and changing antifreeze coolant Precautions for use Komatsu supercoolant Ev (AF-NAC) ery two years or every 4000 hours whichever comes first 1*