. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the water separator holder. cartridge. 4 - 33 6. Loosen the ring nut (4), then remove 7. Pul l 8. Wash screen (6) in Check screen (6) a nd replace it if it is damaged. 9. Wash the inside of case (5) with clean fuel. amaged, o Check case (5). If i t is scratched or d that the position of float (7) cannot be checked, repla ce case ( 5). 10. Install screen (6) to the water separat 11. Replace O-ring (8) with a new part. sert case (5) so t 12. Tighten plug (2), in angle, then fill case (5) carefully with clean fuel. Tightening torque: 1 .5 - 2.5 Nm (0.15 - 0.25 kgm, 1.1 - 1.8 lbft) 13.
Install case (5) to th e water separator holder, the n tighten ring nut (4). Tightening torque: 16 - 20 Nm (1.6 - 2 .0 kgm, 11 .6 - 14.5 lbft) 14. Tighten air intake p Tightening torque: 8.0 - 12.0 Nm (0.8 - 1.2 kgm, 5.8 - 8.7 lbft) 15. Open supply valve 16. After completing th air. For details of the m ethod for bleeding t he air, see "BLEED AIR FROM FUEL CIRC