. MAINTENANCE SERVICE PROCEDURE LUBRICATE CAB MOUNT PIN (LEFT AND RIGHT: 1 PLACE EACH) 1. Stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING mark is at the top 4 - 61 9. When installing, tighten until the packing surface contacts the s eal surface of the filter hold er, then tighten it 3/4 of a turn. If the filter cartrid filter cartridge is When tighteni ge is tightened too far, the packing will be dam aged and this will lead to le akage of fuel.
If the too loose, fuel will also lea k from the packing, so always tighten the corre ng with a filter wrench, be extremely careful n ot to dent or damage the filt 10. Check that the d rain plug at the bottom of t he water separator Tightening torqu e: 0.2 to 0.45 Nm (0.02 to 0.046 kgm, 0.1 to 0 11. After replacing t he fuel main filter cartridge (at intervals of 1,00 0 hours), bleed air. For deta ils, see "REPLACE FUEL MAIN FIL TER CARTRIDGE (PAGE 4-66)". Do not add fuel to the fuel main filter ca rtridge, however. 12. Start the engine, check that there is no l eakage of fuel from the filter seal surface or water separator mounting surface, then ru n for approx. 10 minute s at low idling. 3.
After greasing, w ipe off any old grease that The parts and oil ar e at high temperature after the engine is stopped, an d may cause serious burns. W ait for the temperature to go down before s tarting the operation. If there is still pressu re remaining inside the case, t he oil or plug may fly o ut. Turn the plug slowly to rele ase the pressure, then remove it carefully. 1. Stop the machin and drain plug ( 2. Remove plug (G ) and check that the oil l eve of the plug hole. 3. If the oil level is t oo low, add oil through the oil overflows. 4. Repeat the proc edure in Steps 1 - 3 and add oil to all the final drive cases (front,