. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN TRANSMISSION CASE WARNING the engine is stopped, and may cause burns. Wait for the OIL FILTER ELEMENT (PAGE 4-72) (P). Remove 2 drain plugs (P), drain the oil, then tighten the plug again. brake of oil the oil any 4 - 70 T emperature to go down be When removing the oil fille r cap, turn it slowly to release the in R efill capacity: 115 liter s (30.38 US gal) (including oil in the brake oil tank and each filter c Carry out the following ite ms at the same time in order to d REPLACE TRANSMIS SION FILTER ELEMENT (PAG CHANGE OIL IN TRAN CHANGE OIL IN BRAK SMISSION CASE (PAGE 4-70) E OIL TANK, REPLACE BRAK 1.
Set the container to ca tch the oil directly under the dra REMARK When changing oil in the brake oil tank and replacing the filter element, carry out ste BRAKE OIL TANK, REPL (PAGE 4-72)". ps 1 to 5 mentioned in "CHANGE ACE BRAKE OIL FILTER ELE NOTICE Do not start up the engine wit hout the transmission being filled wi the engine is started up while the transmission is empty or short o transmission hydraulic pump will suffer damage. 2. Before starting the en through oil filler port (F When oil is added, the gine, add 90 liters (23.78 US ga ). level will temporarily go above 3. 4. level on sight gauge abnormality.
Start the engine and r Add oil through oil filler (G), but this does not indica un at low idling. port (F) until the oil level is betw H and L marks on sigh t gauge (G).