. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN BRAKE OIL TANK, REPLACE BRAKE OIL FILTER ELEMENT WARNING cause burns. Wait for the OIL FILTER ELEMENT (PAGE 4-72) Remove drain plug (P), drain the oil, then tighten the plug again. O-ring of 4 - 72 The parts and oil are at h igh temperature immediately after the engine is stopped, and m fore starting the work. r cap, turn it slowly to release the internal pressure, then remove it. temperature to go down be When removing the oil fille r cap, turn it slowly to release the in Prepare a filter wrench Refill capacity:
115 liters (30.38 US gal) (including oil in the transmission case and e Carry out the following item s at the same time in order to REPLACE TRANSMIS SION FILTER ELEMENT (PAG SMISSION CASE (PAGE 4-70 1. Depress the brake ped al at least 20 times to reduce th e pressure inside the brake c 2. Set the container to ca tch the oil directly under drain p 3. Set a container to catch the oil immediately under the fil (1), then remove filter c 4. Take out the element a nd wash the inside of the filter Replace O-ring (2) and backup ring (3) on the filter ca ith clean oil, then install. ent in the filter case, coat the O clean oil, then install. to 98 Nm 2.3 lbft} new parts, coat thinly w 5.
Assemble a new elem the element thinly with Tightening torque: 78.4 {8 to 10 kgm, 57.9 to 7